Re: dfly 2.4.1 does not like HP DL360G4p and Smart Array 6400 with MSA20

["Simon 'corecode' Schubert" <corecode@xxxxxxxxxxxx>]

Sepherosa Ziehau wrote:
> 2009/10/19 Tomaž Borštnar <tomaz.borstnar@over.net>:
> > Hello!
> >
> >        I have a HP DL360G4p machine with 5 gigs of RAM, internal SATA disk
> > and HP SmartArray 6400 controller (2 channels) with 6400EM card (additional
> > 2 channels attached as daughter card) with MSA20 enclosure with SATA disks -
> > configured as 4 volumes. Install went fine, but dmesg prints some errors
> > (full dmesg output attached), but here are relevant parts:
> >
> > bge0: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfddf0000-0xfddfffff
> > irq 7 at device 2.0 on pci2
> > bge0: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
> > alignment check failed
> > miibus0: <MII bus> on bge0
> > brgphy0: <BCM5704 10/100/1000baseT PHY> on miibus0
> > brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> > 1000baseT-FDX, auto
> > bge0: MAC address: 00:15:60:0f:b0:e8
> > bge1: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfdde0000-0xfddeffff
> > irq 7 at device 2.1 on pci2
> > bge1: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
> > alignment check failed
> > alignment check failed
> > miibus1: <MII bus> on bge1
> > brgphy1: <BCM5704 10/100/1000baseT PHY> on miibus1
> > brgphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> > 1000baseT-FDX, auto
> > bge1: MAC address: 00:15:60:0f:b0:e7
>
> I think you mean the "alignment check failed", it is quite common and
> you can jut ignore them

Maybe we should remove the message then? :)

cheers
  simon

--
  <3 the future  +++  RENT this banner advert  +++   ASCII Ribbon   /"\
  rock the past  +++  space for low CHF NOW!1  +++     Campaign     \ /
Party Enjoy Relax   |   http://dragonflybsd.org      Against  HTML   \
Dude 2c 2 the max   !   http://golden-apple.biz       Mail + News   / \