Re: dfly 2.4.1 does not like HP DL360G4p and Smart Array 6400 with MSA20

[Sepherosa Ziehau <sepherosa@xxxxxxxxx>]

2009/10/19 Tomaž Borštnar <tomaz.borstnar@over.net>:
> Hello!
>
>        I have a HP DL360G4p machine with 5 gigs of RAM, internal SATA disk
> and HP SmartArray 6400 controller (2 channels) with 6400EM card (additional
> 2 channels attached as daughter card) with MSA20 enclosure with SATA disks -
> configured as 4 volumes. Install went fine, but dmesg prints some errors
> (full dmesg output attached), but here are relevant parts:
>
> bge0: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfddf0000-0xfddfffff
> irq 7 at device 2.0 on pci2
> bge0: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
> alignment check failed
> miibus0: <MII bus> on bge0
> brgphy0: <BCM5704 10/100/1000baseT PHY> on miibus0
> brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> 1000baseT-FDX, auto
> bge0: MAC address: 00:15:60:0f:b0:e8
> bge1: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfdde0000-0xfddeffff
> irq 7 at device 2.1 on pci2
> bge1: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
> alignment check failed
> alignment check failed
> miibus1: <MII bus> on bge1
> brgphy1: <BCM5704 10/100/1000baseT PHY> on miibus1
> brgphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> 1000baseT-FDX, auto
> bge1: MAC address: 00:15:60:0f:b0:e7

I think you mean the "alignment check failed", it is quite common and
you can jut ignore them

Best Regards,
sephe

-- 
Live Free or Die