Re: Kernel Panic on boot

["Eric J. Christeson" <ejc@xxxxxxxxxxxx>]

I downloaded the 2004-03-17b ISO and tried that.  The result is the
same.  I've attached a verbose boot, but it's essentially the same as
the last, The "Preloaded elf kernel" address is different and some of
the log output is in a different order, but the trace is the same.
Any more ideas?

e
-- 
Eric J. Christeson <ejc@xxxxxxxxxxxx>

`xhnNl'l_o?RhXoJ/}_z+@[x+sP=U/mimx s>E|Pnmavail memory = 121942016 (119084K bytes)
bios32: Found BIOS32 Service Directory header at 0xc00e8050
bios32: Entry = 0xeb1e0 (c00eb1e0)  Rev = 0  Len = 1
pcibios: PCI BIOS entry at 0x3220
pnpbios: Found PnP BIOS data at 0xc00ff020
pnpbios: Entry = ec000:322d  Rev = 1.0
pnpbios: Event flag at ec01e
pnpbios: OEM ID 8224744e
Other BIOS signatures found:
Preloaded elf kernel "/kernel" at 0xc05aa000.
Leaving critical section, allowing interrupts
Pentium Pro MTRR support enabled
Creating DISK md0
md0: Malloc disk
Math emulator present
pci_open(1):	mode 1 addr port (0x0cf8) is 0x8000005c
pci_open(1a):	mode1res=0x80000000 (0x80000000)
pci_cfgcheck:	device 0 [class=060000] [hdr=00] is there (id=71908086)
pcibios: BIOS version 2.10
Using $PIR table, 8 entries at 0xc00fe840
PCI-Only Interrupts: none
Location  Bus Device Pin  Link  IRQs
embedded    0    7    D   0x63  10
embedded    0   10    A   0x60  10
embedded    0   10    B   0x61  10
embedded    0   12    A   0x60  3 4 5 7 9 10 11
embedded    0   16    A   0x62  3 4 5 7 9 10 11
embedded    0    1    A   0x61  3 4 5 7 9 10 11
embedded    0   13    A   0x60  3 4 5 7 9 10 11
embedded    0   14    A   0x60  3 4 5 7 9 10 11
embedded    0   15    A   0x60  3 4 5 7 9 10 11
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
pci0: physical bus=0
	map[10]: type 1, range 32, base a0000000, size 26
found->	vendor=0x8086, dev=0x7190, revid=0x03
	bus=0, slot=0, func=0
	class=06-00-00, hdrtype=0x00, mfdev=0
	subordinatebus=0 	secondarybus=0
found->	vendor=0x8086, dev=0x7191, revid=0x03
	bus=0, slot=1, func=0
	class=06-04-00, hdrtype=0x01, mfdev=0
	subordinatebus=1 	secondarybus=1
found->	vendor=0x8086, dev=0x7110, revid=0x02
	bus=0, slot=7, func=0
	class=06-80-00, hdrtype=0x00, mfdev=1
	subordinatebus=0 	secondarybus=0
	map[20]: type 1, range 32, base 00001100, size  4
found->	vendor=0x8086, dev=0x7111, revid=0x01
	bus=0, slot=7, func=1
	class=01-01-80, hdrtype=0x00, mfdev=0
	subordinatebus=0 	secondarybus=0
	map[20]: type 1, range 32, base 0000f300, size  5
found->	vendor=0x8086, dev=0x7112, revid=0x01
	bus=0, slot=7, func=2
	class=0c-03-00, hdrtype=0x00, mfdev=0
	subordinatebus=0 	secondarybus=0
	intpin=d, irq=10
	map[90]: type 1, range 32, base 00001400, size  4
found->	vendor=0x8086, dev=0x7113, revid=0x02
	bus=0, slot=7, func=3
	class=06-80-00, hdrtype=0x00, mfdev=0
	subordinatebus=0 	secondarybus=0
found->	vendor=0x104c, dev=0xac1c, revid=0x01
	bus=0, slot=10, func=0
	class=06-07-00, hdrtype=0x02, mfdev=1
	subordinatebus=0 	secondarybus=0
	intpin=a, irq=255
found->	vendor=0x104c, dev=0xac1c, revid=0x01
	bus=0, slot=10, func=1
	class=06-07-00, hdrtype=0x02, mfdev=1
	subordinatebus=0 	secondarybus=0
	intpin=b, irq=255
	map[10]: type 1, range 32, base 00003100, size  8
found->	vendor=0x125d, dev=0x1978, revid=0x10
	bus=0, slot=16, func=0
	class=04-01-00, hdrtype=0x00, mfdev=0
	subordinatebus=0 	secondarybus=0
	intpin=a, irq=5
agp0: <Intel 82443BX (440 BX) host to PCI bridge> mem 0xa0000000-0xa3ffffff at device 0.0 on pci0
agp0: allocating GATT for aperture of size 64M
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pcib1:   secondary bus     1
pcib1:   subordinate bus   1
pcib1:   I/O decode        0x8000-0x9fff
pcib1:   memory decode     0xd8000000-0xdfffffff
pcib1:   prefetched decode 0xd0000000-0xd7ffffff
pci1: <PCI bus> on pcib1
pci1: physical bus=1
	map[10]: type 1, range 32, base d8000000, size 24
	map[14]: type 1, range 32, base 00008000, size  8
	map[18]: type 1, range 32, base d9000000, size 12
found->	vendor=0x1002, dev=0x4c42, revid=0xdc
	bus=1, slot=0, func=0
	class=03-00-00, hdrtype=0x00, mfdev=0
	subordinatebus=0 	secondarybus=0
	intpin=a, irq=10
pci1: <ATI model 4c42 graphics accelerator> (vendor=0x1002, dev=0x4c42) at 0.0 irq 10
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0x1100-0x110f at device 7.1 on pci0
ata0: iobase=0x01f0 altiobase=0x03f6 bmaddr=0x1100
ata0: mask=03 ostat0=50 ostat2=00
ata0-master: ATAPI 00 00
ata0-slave: ATAPI 00 00
ata0: mask=03 stat0=50 stat1=00
ata0-master: ATA 01 a5
ata0: devices=01
ata0: at 0x1f0 irq 14 on atapci0
installed MI handler for int 14
ata1: iobase=0x0170 altiobase=0x0376 bmaddr=0x1108
ata1: mask=03 ostat0=50 ostat2=01
ata1-master: ATAPI 14 eb
ata1-slave: ATAPI 14 eb
ata1: mask=03 stat0=00 stat1=01
ata1: devices=0c
ata1: at 0x170 irq 15 on atapci0
installed MI handler for int 15
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xf300-0xf31f irq 10 at device 7.2 on pci0
installed MI handler for int 10
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
ums0: Logitech USB Mouse, rev 1.10/4.10, addr 2, iclass 3/1
ums0: 3 buttons and Z dir.
pci0: <Intel 82371AB Power management controller> (vendor=0x8086, dev=0x7113) at 7.3
cbb0: <TI1225 PCI-CardBus Bridge> at device 10.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
pci_cfgintr_linked: linked (60) to hard-routed irq 10
pci_cfgintr: 0:10 INTA routed to irq 10
	using shared irq10.
cbb1: <TI1225 PCI-CardBus Bridge> at device 10.1 on pci0
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1
pci_cfgintr_unique: hard-routed to irq 10


Fatal trap 12: page fault while in kernel mode
fault virtual address	= 0xeb861
fault code		= supervisor read, page not present
instruction pointer	= 0x8:0xc00eb747
stack pointer	        = 0x10:0xc05ccaec
frame pointer	        = 0x10:0xc05ccaec
code segment		= base 0x0, limit 0xfffff, type 0x1b
			= DPL 0, pres 1, def32 1, gran 1
processor eflags	= interrupt enabled, resume, IOPL = 0
current process		= 0 (swapper)
current thread          = pri 12 
interrupt mask		= net tty bio cam 
kernel: type 12 trap, code=0
Stopped at      0xc00eb747:     cmpb    %cs:0x1(%esi),%bl
db> trace
kernbase(c5f2b470,c03e5399,c05ccba0,a0b,50) at 0xc00eb747
_end(cb9d08c4,c4f6ec8b,81067540,ffffe5,e67f2400) at 0xc05ccb58
db>