Re: acx wireless HOWTO.

["Sepherosa Ziehau" <sepherosa@xxxxxxxxx>]

On 4/1/07, Vladimir Mitiouchev <vovcia@miauk.net> wrote:
> Hello :-)
> I'm trying to run my acx card.
> acx0@pci0:18:0: class=0x028000 card=0x3b011186 chip=0x8400104c rev=0x00 hdr=0x00
>     vendor   = 'Texas Instruments (TI)'
>     device   = 'PCI-2422 802.11b+ 22Mbps Wireless Adapter'
>     class    = network
>
> I've searched google a lot, found some firmware but im not sure which
> one should i use. I've found some info about radio firmware stuff but
> i don't know if my card need it. acxcontrol acx0 -f firmware just do
> nothing and when ifconfig acx0 up driver is complaining about missing
> firmware.

I use firmware in following link to test acx(4):
http://leaf.dragonflybsd.org/~sephe/acx/acx_fw.tbz

After extracting the above tar ball, you need to run following command
to load the firmware:
acxcontrol acx0 -f acx_fw/acx100/wlangen.bin -r

> Please, give me some instructions how to setup this card.
> I want to run it in AP mode, is it possible?

Yeah, it is possible, but only WEP or 'no protection' is supported.

ifconfig acx0 channel 1
ifconfig acx0 ssid your_ssid
ifconfig acx0 mediaopt hostap
# if you need WEP:
# ifconfig acx0 wepmode on wepkey 0x1234567890 weptxkey 1
ifconfig acx0 inet your_ip

Putting ifconfig up/inet in the last step can save you some firmware
(re)loading and hardware reinitialization time.

Best Regards,
sephe

--
Live Free or Die