Installing Dragonfly 1.8 hangs BIOS completly

[Michael Neumann <mneumann@xxxxxxxx>]

Hi,

Just a few minutes ago, I installed Dragonfly 1.8 onto my laptop.
Then I rebooted, and the BIOS hung up completely after showing that it 
detected the harddisk and cdrom. I powered down and tried again, but 
that didn't worked either. I couldn't even boot a CD or anything else or 
couldn't even enter the BIOS setup.

The only thing that worked was to remove the harddisk physically and 
then pluging it in a few seconds after the BIOS crossed the detection of 
the devices. Using this method, I booted the Dragonfly installer cd and 
used the disk tools to wipe out the beginning of the harddisk. Then I 
rebooted again and voila, I could boot normally (without removing the 
harddisk). Puh!

Now I tried a second time to install Dragonfly 1.8, but after I reboot 
the BIOS hangs again!

I know that the BIOS should not hang up itself, but on the other hand 
that didn't happen with any other operating system I installed on my 
laptop (FreeBSD, NetBSD, DragonFly 1.6). So I think there is something 
wrong in the 1.8 version. Any hints?

Regards,

  Michael