Re: cvsup, installer and booting

[Adonijah <adonijah@xxxxxxxxx>]

George Georgalis wrote:
> I had more serious problems on my second machine. The installer uses
> UDMA33. Linux has problems setting the speed automatically (it uses
> UDMA66), but I can speed it up manually (commands below). The bios
> supports ATA 133 and there is a (1 channel) 80 pin ribbon. Can I fix
> this from the DragonFly installer?

DragonFly (and FreeBSD) are very picky about the cabling you use for 
your hard drives. I can't say that it's completely correct since I had 
the same experience you did while I had no problems with Linux or 
Windows detecting my cabling correctly. But, I can tell you that when I 
swapped the hard drive cable out for another one, suddenly DragonFly 
detected the cable correctly and used UDMA100 (in my case).