Re: not always reproducable installer problem

[Dru <dlavigne6@xxxxxxxxxxxx>]

On Tue, 28 Aug 2007, Matthew Dillon wrote:

>    There are several possibilities.  It could be a driver issue (1.8 used
>    the original ATA driver while 1.10.x uses NATA), but driver issues
>    usually have more consistent failures.
>
>    It could also be cabling or heat related.  I noticed that the driver
>    connected to the drive at UDMA100.  Is this an old machine?  Is it a
>    laptop or desk top?


Could possibly be heat... System 1 is an older desktop. System2 is a 
newer laptop which I usually leave plugged in and on 24/7.

System 1 was cool when I tested last night/this morning; I didn't retry 
on system2 as I had just reinstalled it. I'll try leaving system1 on for a 
while then check if the error is reproducable.

Thanks for the prompt reply,

Dru